440-946-3200
Check Stock/
Pricing

NEMA vs. IP Enclosure Protection Ratings

Electrical enclosures are rated based on their ability to withstand a varying degree of environmental elements, including dust, water, and ice. In the United States, the National Electrical Manufacturers Association developed the NEMA rating for classifying an enclosure’s level of protection from those environmental elements. The International Electrotechnical Commission (IEC) http://www.iec.ch/index.htm has developed an alternative rating system, the IP standard, which stands for Ingress Protection. The standard format is “IP’ followed by two numbers which designate the level of protection. The first digit, which ranges from 1-6, specifies the level of protection from solids, and the second digit, which ranges from 1-8, specifies the level of protection from water. The higher the number is, the greater the level of protection. For instance, an enclosure with a rating of IP10 would offer less protection than an enclosure that is rated at IP54.

The following table summarizes the various IP number designations:

First Number Protection From Solid Objects Second Number Protection From Water
0 No protection 0 No protection
1 Protected from solid objects over 50mm 1 Protected from vertically falling drops of water
2 Protected from solid objects over 12mm 2 Protected from direct sprays of water up to 15 degrees from vertical
3 Protected from solid objects over 2.5mm 3 Protected from direct sprays of water up to 60 degrees from vertical
4 Protected from solid objects over 1mm 4 Protected against sprays from all directions - limited ingress permitted
5 Protected from dust-limited ingress 5 Protected from low pressure jets of water from all directions - limited ingress permitted
6 Totally protected from dust 6 Protected against  strong jets of water - limited ingress permitted
NA   7 Protected from the effects of temporary immersion between 15cm and 1m
NA   8 Protected against long periods of immersion under pressure

There is not a direct correlation between NEMA ratings and IP ratings, as the two systems are based on a different set of variables. However, the table below shows an approximate cross reference that can be used to help determine the IP number that meets or exceeds a particular NEMA rating.

NEMA IP
1 10
2 11
3 54
3r 14
3s 54
4 and 4x 55
5 52
6 and 6p 67
12 and 12k 52
13 54